Tunnel projector mounted on a drilling rig in front of the operator. Here the projector is used to check and mark before the drilling operation starts. Electricity comes from the drilling rig. This installation is smart as the system is always there and none need to carry it around and work with cables. Rockset has worked with this technology for over 30 years and have references world wide . The technology has proved to be very cost effective and profitable. The projector saves time as the time to mark the drilling pattern on the wall is cutted dramatically and time is money. The exact drilling possible by a projector saves the over waist often common as there is too much area in the tunnel. This expense is very large . |
|||
The pattern can be aligned to a tunnel laser spot. The scale of the pattern is set by a scale or by the use of 2 pcs of tunnel laser beams where pattern is aligned with the zoom optics to fit booth spots at the same time. This makes scale correct. This marking complete with on and off of projector takes normally less 5 minutes and need no surveyor for the job. |
|||
We give the knowledge how to do this work in the teach in we normally do when we make a delivery. Often our specialist comes and deliver the system and have a training with the operators. This makes it sure that the system is operated in the most efficient and profitable way. |
|||
The edge pattern from the tunnel projector defines the outer shape of the tunnel and it is important to no make the tunnel too large. Then the Proj 2001 tunnel projector helps a lot. |
| LaseroptronixAB |
|
Telephone 46-70 714 04 70
|
| Enhagsslingan 23 |
|
|
| 187 40 Täby |
|
Säte i Täby Kommun Glimmervägen 8 187 34 Täby / Sweden |
| Sweden North Europe |
|
Created 2005-10-27 by Allan Jansson
|